![]() ![]() ( I notice my prints would start fine then slowly migrate to the left almost like it was doing the image in a large italic slant. This will save you from a headache and confusion down the road. Move both the laser head and table back and forth a few times by hand to spread it out. Push the laser head and table to one side and apply a thin layer of oil to the drive screws and the ways (or guide Bars) then move them to the other side and do the same. ![]() Make sure you get a very fine oil (like starrett oil or slip 2000) and some q-tips. It in no way effected anything on the engraver! I glued leg back on and it runs like nothing happened. I dropped the whole unit on my hard wood floor from 4 feet by accident and busted one of the legs off. ![]() The quality you get for the money it costs is amazing. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |